NTN Driveshaft CORP.

Self Aligning Ball Bearings

A self-aligning bearing is recommended when the alignment of the shaft and housing is difficult or when the shaft may bend during operation. Brda notes that similar to deep groove ball bearings, most self-aligning ball are for general use.
Depending on the series, most self-aligning bearings can be interchanged with standard ball bearing assemblies. (6200 and 6300 have direct interchanges with the 1200 and 1300 series). “However, if this is not possible, the self-aligning bearing may be wider or can have a tapered bore,” Brda explains.

Normal mounting and handling procedures for a cylindrical bore bearing should be followed. For the tapered bore, special care must be taken to ensure the bearing is driven up the taper the appropriate amount. Because matching the bearing to the specific application is critical, it is important to verify your application need with your selected vendor.

25 mm x 52 mm x 18 mm FAG 2205-K-TVH-C3 self aligning ball bearings
4.1 Hz
4.92 Hz
30 mm x 62 mm x 16 mm NTN 1206SK self aligning ball bearings
CX
700 r/min
17 mm x 47 mm x 19 mm KOYO 2303 self aligning ball bearings
4.1 Hz
4.92 Hz
65 mm x 120 mm x 31 mm FAG 2213-TVH self aligning ball bearings
CX
700 r/min
Toyana 11305 self aligning ball bearings
18 mm
155 Kg
◂ Previous page Next page ▸
All Products Contact Now
Product Categories
Angular Contact Ball Bearings
Bearing Units
Cylindrical Roller Bearings
Deep Groove Ball Bearings
Needle Roller Bearings
Plain Bearings
Self Aligning Ball Bearings
Spherical Roller Bearings
Tapered Roller Bearings
Thrust Ball Bearings
Thrust Roller Bearings
Wheel Bearings
608rs Bearing
aisi 52100 Bearing
l68149 Bearing
lm16uu Bearing
Tapered Roller Bearings Tapered Single Metric